Order status and workflow
From "Open" to "Done": what each status means, how rework works and how to correct mistakes.
Every order goes through fixed stages. The allowed transitions are the same on the web and in the app.
The statuses
| Status | Meaning |
|---|---|
| Open | created, no date yet |
| Scheduled | date and usually a technician are set |
| In progress | the technician has started on site |
| Further appointments required | another visit is needed, e.g. because of materials |
| Completed | work done, report available |
| Invoicing / Invoiced | invoice is being prepared or has been created |
| Done | payment received, nothing left to do on the order |
| Rework | a finished order was reopened because something still needs to be done |
| Cancelled | order dropped (can be reopened) |
There are also obstacles on site that the technician reports directly: Not at home and No access. They tell the office right away that a new appointment is needed.
Typical workflow
- The office creates and schedules the order (Scheduled).
- The technician starts the order in the app (In progress), takes photos and writes the report.
- With the signature they finish the job (Completed). Open mandatory fields of an inspection report prevent completion.
- The office creates the draft invoice (Invoicing, then Invoiced).
- Once the payment has arrived, the office sets the order to Done. Without an invoice (e.g. a warranty case) this also works directly after Completed.
Rework
If something needs to be done again on a finished order, for example after a complaint, set it to Rework. This works from Completed, Invoiced and Done. AuftragsDesk asks what needs to be done. The text is recorded in the order history.
- With a new date the order becomes Scheduled again and shows up in scheduling, the duty roster and the app. The customer can book a date in the customer portal if online booking is active.
- The technician starts it as usual. The rework is a separate visit with its own order report, and inspection reports can be edited again.
- Afterwards the order is Completed again and finally Done. If the rework is no longer needed, you can set it straight back to Completed or Done.
- An invoice that has already been created stays unchanged. Whether you charge for the rework is up to you.
In the statistics, the rework rate shows how many of the completed orders needed rework at least once.
Started by mistake
If a technician started the wrong order in the app, or the customer is not there after all, they tap Cancel workflow in the order workflow. After a confirmation the order is back to where it was before the start, e.g. Scheduled, and can be started again later. Before-images on the device can be deleted at the same time. This only works as long as no job report exists for this visit. The order history shows the cancellation ("Start cancelled in the app"). Once a report exists, the technician reports an obstacle instead or finishes with "further appointments needed".
Back to "Open"
When an order is set back to Open, its date is removed: it disappears from scheduling and the duty roster, and reminders to the customer are no longer sent. The assigned employees receive a single "appointment cancelled" message. The assignment stays.
Setting a status freely
To correct mistakes, the order page has a collapsed section Set status manually. It needs a separate permission and asks for confirmation. Every change is recorded in the order history.